
16 November 2026
- Botswana’s Department of Mines has approved two shallow exploration pits at Airstrip and Dibete
- The pits will expose near-surface mineralisation and provide up to 100t for testwork
- Historical drilling has outlined copper-silver mineralisation beneath both planned pits
Special Report: Verity Resources can progress exploration at its Botswana copper-silver portfolio after securing approval to excavate exploration pits at two copper-silver prospects for the mapping of near-surface mineralisation.
Airstrip and Dibete lie about 6.5km apart along the Magogophate Shear Zone in the Limpopo Mobile Belt. At both prospects, near-surface copper oxide and supergene mineralisation overlie primary sulphides at depth.
Verity Resources (ASX:VRL) has approval from Botswana’s Department of Mines to dig one 10m pit at each prospect, subject to submission of a pit design report.
The pits will expose oxide and supergene mineralisation in their walls and floors, helping geologists map structures that control high-grade shoots and compare channel samples with nearby drill results.
VRL director Patrick Volpe said the approval to open exploration pits at Airstrip and Dibete would mark the first time the company could expect to see near-surface mineralisation
Exploration pits
At Airstrip, the priority C6 pit will cross electromagnetic conductor C63, above a previously drilled, bornite-bearing copper-silver shoot. Surface mapping and trenching within the pit outline have recorded gossan and copper oxide.
Historical Airstrip drilling returned 11m at 7.63% copper and 462g/t silver from 52m, including 3m at 22.74% copper and 1379g/t silver.
Those intervals sit below the planned 10m pit floor.
Dibete Pit 1 will target the north-western end of a supergene copper-silver zone, where oxide minerals reach surface alongside historical copper workings and trenches. Historical drilling within and near the proposed footprint includes 10m at 2.04% copper and 15.6g/t silver from 7m, and 25m at 2.17% copper and 77g/t silver from 27m. Most of those intercepts are below the planned pit floor.
“Just as importantly, the pits give us enough material to run proper metallurgical testwork on the oxide and supergene copper at both prospects,” Volpe said.
Each pit will be excavated from the top down in two 5m benches, with mineralised material from each bench kept separate for logging, sampling and analysis. An excavator and articulated dump truck will be used, with stockpiles set at least 5m from the pit edge. The pits and stockpiles will be fenced, and waste will be held aside for later rehabilitation.
Pit walls and floors will be geologically logged and sampled, with samples sent to accredited laboratory SGS South Africa for analysis.
Bulk sampling and testwork
Up to about 100t of oxidised material will be collected for mineralogical and metallurgical testwork, including analysis of copper, silver and other base metals and recovery testing using conventional and newer methods.
Samples are expected to be packed in one-tonne bags for laboratories in South Africa and Australia.
However, shipment of samples will require VRL to obtain a Department of Mines export permit, which it will apply for once the pits are open.
Planned testwork includes crushing, pulverising and particle-size analysis, mineralogy by quantitative XRD and petrography, and extraction and recovery testing using conventional and newer processing methods. The field team has begun defining the final pit coordinates, with excavation to start once a contractor is appointed. After excavation, VRL plans to map, log and sample the exposures, report results under the JORC Code 2012 and progressively rehabilitate the sites.
*This article was developed in collaboration with Verity Resources, a Stockhead advertiser at the time of publishing. This article does not constitute financial product advice. You should consider obtaining independent advice before making any financial decisions.
Source: https://shorturl.at/1OSe8



